Table of Contents

Membuat tugas akuisisi laser (E57)

Artikel ini menjelaskan alur kerja lengkap untuk tugas akuisisi laser dalam format E57, termasuk pembuatan tugas, upload data, dan proses pemetaan, untuk membantu pengguna menyelesaikan seluruh alur kerja akuisisi dan pemetaan laser E57 secara standar.

Membuat tugas akuisisi laser E57

After creating a project, click Manage to enter the mapping task management page (skip this step for Mega Go). Click the Laser acquisition task button in the upper-right corner. In the pop-up dialog, enter Task name, select E57 format for Data type, use the latest version for Mapping version and Data format, and click Confirm add to create a Qiyu acquisition task.

Create E57 laser acquisition task

Create E57 laser acquisition task

Persiapan data

Before starting a mapping task, make sure the acquired spatial data meets the requirements and is organized and stored according to the specifications. The following sections describe data acquisition and export in detail.

Akuisisi dan ekspor data

Use a laser scanner to acquire spatial data. For related device configuration and acquisition points, see:

Unggah data

Klik Unggah data dan pilih opsi yang sesuai di jendela pop-up. Detail setiap opsi dijelaskan di bawah: Upload E57 laser mapping data

Lokasi data

The available upload methods vary depending on the region where the mapping project is located:

China Region 1

Depending on the data source and storage method, you can choose either of the following methods:

  • Local new data
  • Uploaded data (not supported by Mega Go)

Global

Only Local new data is supported.

Data akuisisi

Upload a file with the .e57 suffix. Click Select, choose the specified file in the directory, and click Open. Upload Qiyu laser mapping data

Konfirmasi upload

  • After clicking Confirm upload, the list displays the upload progress and status.
  • During data upload, keep the computer powered on and the network connected. Do not close the browser, refresh the page, or click other menus; otherwise the upload will be interrupted and must be performed again.

Mulai pemetaan

After data upload is complete, the mapping process starts automatically. The status is displayed as Queued or Generating, as shown below. Wait patiently for mapping to complete.

Mapping task generating

Fungsi bantuan

The following functions help you manage and operate mapping tasks more efficiently:

Melihat file yang di-upload

Click View uploaded files to view all uploaded files in the dialog and confirm that all files have been uploaded, avoiding mapping failures caused by missing files.

View uploaded files

Menghentikan pemetaan

Before the mapping task is complete, if you find that the wrong data was uploaded or the trajectory data does not match the actual situation, click Stop mapping, then click Confirm in the second confirmation dialog to stop mapping.

Stop mapping

Menghapus tugas

If the current mapping task failed or is no longer needed, click Delete task to delete it. Click Delete in the second confirmation dialog to complete the deletion.

Delete task

Mengonfirmasi hasil pemetaan

After the task enters the mapping process, you can determine whether the mapping task is complete from Task status. When the status is Task complete or Generation failed, the mapping task has ended.

Mapping task complete

Pemetaan berhasil

When the task status is Task complete, mapping succeeded and the mapping result has been generated. You can further inspect the result and confirm whether it meets expectations.
View mapping results:

Pemetaan gagal

When the task status is Generation failed, mapping failed. Troubleshoot the problem as follows:

  • View mapping report: View mapping report and find a solution based on the report information.
  • Refer to troubleshooting: Read the mapping failure troubleshooting guide for common solutions.
  • Contact technical support: If the methods above do not solve the problem, contact EasyAR staff and provide the JobID from the mapping report for fast diagnosis.

Topik terkait